It could be useful to add a "Center" options for the label offset in (structural) rules. Now there is only "Above" and "Below", which makes sense in combination with single line resymbolization. However for eg. concrete beams that are wide enough ...

For Architectural and Mechanical drawing rules it is already possible to use the DG catalog to assign a rule to the elements it must be applied to. For Structural drawing rules only the Family/Part can be used. Please provide similar functionality...

Something that would be very handy is a tool that would move elements to a preset rl. This would be a much easier option over using the move command in large models. Would also be great is there was an option to flatten raked members.

When setting up the OBD build, ideally, you would have the Part (beam, column, bracing etc.) and then use the Cat to set up Beam options by type, including the Placement Point (PP). eg. Part-Beam\Cat-Primary Beam with PP set to top-centre, Part-Be...